3. Always unplug heater when not in use.
4. Do not operate any heater with a damaged cord or plug or after
heater malfunctions, has been dropped or damaged in any way.
5. Do not use outdoors.
6. This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may
fall into a bathtub or other water container.
7. Do not run cord under carpeting. Do not cover cord with throw
rugs, runners or the like. Arrange cord away from traffic area and
where it will not be tripped over.
8. To disconnect heater, turn controls to "OFF" before removing
plug from outlet.
9. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or fire or
damage the heater.
10. To prevent possible fire, do not block air intakes in any
manner.
11. Use this heater only as described in this manual. Any other
use is not recommended by the manufacturer which may cause
fire, electric shock or injury to people and/or animals.
12. Always use properly grounded fused and polarized outlets.
13.Always use ground fault protection where required by
electrical codes.
14. Always disconnect power before performing any cleaning,
maintenance or relocation of heater.
15. Always plug heaters directly into a wall outlet/receptacle.
Never use with an extension cord or relocatable power tap
(outlet/power strip).
16. To prevent a possible fire, do not burn wood or other
materials in this heater.
17. To prevent electric shock or fire, always use a certified
electrician should new circuits or outlets be required.
18. When transporting or storing heater, keep in a dry place free
from excessive vibration and damage.
19. The heater must not cover up an electrical socket; the socket
must always be accessible in order to disconnect the heater from
the electrical supply for maintenance and cleaning.
20. This heater must be grounded. The main supply must be
Safely routed from the heater to an electrical socket
.
Note: When the heater is turned on for the first time, it may
release a slight, harmless odor or smoke. This odor or smoke is a
normal occurrence caused by the initial heating of the internal
heating elements and should not occur again.
SAVE THESE INSTRUCTIONS
Technical Specification
Description of product
ELECTRIC FIREPLACE
Model
80-2000A-36,80-2000A-42,80-2000A-54
Rated Voltage
120V~
Rated Frequency
60 Hz
Rated Power
1500W
Lamp
LED
Unpacking and Testing
1. Carefully remove the unit from the box. Prior to using the unit,
test to make sure the unit operates properly. Plug the unit's
power supply cord into a conveniently located 120volt
grounded
