Need help? Call +1 (360) 764-8850 or email [email protected]
v4.2 Jan 2021| Page 21
15.
Remove pushrod detent and spring as shown in figure 14.
Figure 14: Push rod detent removal
16.
Disassembly is complete.
4.2
Reassembly
1.
Reinstall the pushrod detent and spring (figure 14). The groove in the pushrod detent should be
oriented to the left so that it will accept the push rod when it is pulled back.
2.
Install the push wire and push wire slide onto the feed tube (figure 15). Note the nesting needle
which is permanently installed in the groove on the bottom of the feed tube. Note the “l” in the rear
end of the push wire which fits in the small retaining hole in the push wire slide.
Insert screwdriver
through the hole to
remove the detent
nut
Detent and
detent spring
Detent nut
