Operating the Pressure Washer
30 |
P a g e
Any Questions, Comments, Problems, or Parts Orders
Call NorthStar ProSHOT Product Support 1-800-969-7073
Turn counter-clockwise
to reduce pressure.
Turn clockwise to
increase pressure.
8)
The pressure washer’s unloader is adjustable. It
is set and locked to the maximum rated pressure when it
leaves the factory. To reduce the pressure, turn the unloader knob counter-clockwise,
to return it to the factory set maximum pressure, turn clockwise.
WARNING
:
Do not attempt to alter the unloader valve's maximum
pressure. Excess pressure could cause serious injury from escaping
high-pressure fluids and/or pump damage. Any alteration other than
turning the adjustment knob will void your warranty.
9)
If temporarily interrupting spraying, rotate trigger safety latch
downward to the locked position to guard against accidental
trigger release.
10)
Always turn off the engine and activate spray gun trigger to relieve
system pressure when:
•
the sprayer is unattended, or
•
the operator is disconnecting hoses, installing/cleaning nozzles, or servicing the pump.
WARNING:
Always turn off the engine and relieve system pressure when finished spraying or when leaving sprayer
unattended. Serious injury could result from unintentional release of high-pressure spray.
STEP 4. STOPPING
Stop the engine using the following steps:
WARNING:
Never disconnect the high-pressure hose from the pump or spray gun while the system is pressurized. Relieve pressure by
squeezing the spray gun trigger after the engine is turned OFF.
1)
If the heater was used, turn thermostat OFF.
2)
Spray cold water for two minutes.
3)
Turn heat switch OFF.
4)
Turn engine OFF.
Squeeze trigger to relieve pressure.
