Before Each Use
16
2)
Check and clean the nozzle orifice.
3)
Clean inlet filter. (See Maintenance instructions)
Inspect fuel
system
Always inspect (engine and burner) fuel systems & check for leaks BEFORE
starting pressure washer.
Do not start pressure washer until all needed repairs have been completed.
WARNING:
Fuel leak hazard
Gasoline and burner fuels are highly explosive and fuel leaks can result in
fire or explosions. You can be burned and seriously injured if the fuel
system is not properly hooked up or there is a fuel leak when you start the
engine.
Inspect the entire fuel system. Look for:
•
signs of leaks or deterioration,
•
chafed or spongy fuel hose,
•
loose connections,
•
loose or missing fuel hose clamps,
•
damaged gasoline tank, or
•
defective gasoline shut-off valve.
Perform other
scheduled
maintenance as
needed
Make sure that any other regular maintenance has been performed as prescribed
in this manual in the “Maintenance & Repair” section.
1.
Refer to the engine owner’s manual for engine maintenance instructions.
2.
Make sure battery is charged. Charge as needed according to your battery
manufactur
er’s inst
ructions.
STEP 2. ADD FUEL(S)
WARNING
:
Fuel fire/explosion hazard
Gasoline is highly flammable and explosive.
Burner fuels are
combustible at warm temperatures.
Heat, sparks, and flames can
ignite fuel vapors, which can become widespread during fueling. A
flash fire and/or explosion could result and cause serious injury or
death. Always use extreme care when handling fuels. Carefully follow
all instructions to avoid the following conditions which could result in
fuel ignition:
•
gas vapor collection inside enclosures
•
static electric sparks
•
sparks from electric wiring, batteries, or running engines
•
sources of heat (such as a hot engine, burner or exhaust)
•
open flames, including pilot lights
Always follow these general safety rules when fueling:
1) Turn pressure washer off and allow to cool for at least two minutes before removing any fuel cap.
Note: A running, or still-hot engine or burner is hot enough to ignite fuel.