NorthStar LITE, Руководство по применению

Страница: 12 / 14

12
3
Secure the battery on the shelf if it is needed and possible.
4 NOTE: When batteries are mounted on a shelf no stacking is
allowed.
5 Connect the
cables
according to
item 9-12
above.
6 Start-up
Set circuit
breaker in
the ON
position.
4.4.1 Allowed installation directions of the battery
4.4.2 ADD switch
The ADD switch is used to control the address in the BMS.
It is not recommended to use more than 10 batteries in
parallel.
1 2 3 4 Address
0 0 0 0 0
1 0 0 0 1
0 1 0 0 2
1 1 0 0 3
0 0 1 0 4
1 0 1 0 5
0 1 1 0 6
1 1 1 0 7
0 0 0 1 8
1 0 0 1 9
0 1 0 1 10
1 1 0 1 11
0 0 1 1 12
1 0 1 1 13
0 1 1 1 14
1 1 1 1 15
4.5 Led Indicators and Alarms
The Battery Unit is equipped with six (6) LED indicators
positioned on the front panel which indicate the status of
the system, as described by the table below. See section 2.4
Determining State-of-Charge, for introduction to the
capacity indicators.
Battery Unit Mode
Normal/Alarm/Protection/
Failure
ALM RUN Capacity
O O O O O O
Shutdown/Sleep OFF OFF ALL OFF
Standby
Normal OFF
Flash
1
Capacity display Protection
Flash
2
Alarm
Flash
3
Failure ON OFF ALL OFF
Charge
Normal OFF
Flash
2
Capacity display Protection
Flash
2
Alarm
Flash
3
Failure ON OFF ALL OFF
Discharge
Normal OFF
ON Capacity display Protection
Flash
2
Alarm
Flash
3
Failure ON OFF ALL OFF
Flash mode ON OFF
Flash 1 0.25 s 3.75 s
Flash 2 0.5 s 0.5 s
Flash 3 0.5 s 1.5 s
4.5.1 Faults
If the battery malfunctions the red ALM light will be flashing,
see above.

Check that the battery is connected in a correct
manner.

Press the reset button to see if the problem is solved

If it is not resolved, contact the manufacturer.
Circuit breaker