SECTION THREE: Installing and wiring the 2201
957 Installation Manual, Revision C1
Page 19
•
below the radiation plane of any INMARSAT or radar
antennas, and away from any other high-power
transmitting antennas (see Figure 8 on page 19).
•
high enough to provide an unblocked view of the sky in all
directions, and that minimizes or eliminates any objects
that block the 2201’s view of the sky (the 2201 uses
satellites down to zero degrees elevation or to the horizon).
•
away from masts or objects that could “shadow” the 2201,
but where there’s an adequate view of the sky.
To avoid mutual interference among different antennas on the
vessel, see the recommendations in Figure 8 below. This figure
shows the minimum distances that should separate GPS/WAAS
antennas from other antennas and physical mounting surfaces.
Normally, these guidelines produce a relatively trouble-free
installation. However, you may want to adjust these distances
to the particular equipment, since every installation is unique.
Figure 8: Recommended separation distances between antennas
Mounting the 2201
You can mount the 2201 in one of two ways:
•
onto a standard antenna mast
•
onto a flat surface
Содержание 957
Страница 28: ...SECTION THREE Installing and wiring the 2201 Page 24 957 Installation Manual Revision C1 ...
Страница 34: ...SECTION FOUR Installing and wiring the 2701 Page 30 957 Installation Manual Revision C1 ...
Страница 42: ...SECTION FIVE Checking out the system Page 38 957 INSTALLATION MANUAL Revision C1 ...
Страница 70: ...APPENDIX A 957 system technical specifications Page 66 957 INSTALLATION MANUAL Revision C1 ...