NorthStar 157495, Руководство пользователя, Страница: 15 / 32

15
Before Each Use
Step 1: Inspect Equipment
Electrical

Inspect power cord before using. Do not use if cord
is damaged.

Connect only to properly grounded outlet.

Keep all connections dry and off the ground.

Do not touch plug with wet hands.

If product is provided with a GFCI built into the power
cord plug, use only identical parts if replacement is
necessary.
Burner Fuel System
Inspect burner fuel system for leaks BEFORE starting
pressure washer. Look for:

Signs of leaks, wetted areas, or deterioration

Chafed or spongy fuel hose

Loose connections

Loose or missing fuel hose clamps

Damaged fuel tank
WARNING: Fuel leak hazard
Burner fuels are highly flammable and fuel leaks can
result in fire or explosions. You can be burned and
seriously injured if there is a fuel leak when you start
the pressure washer.
Periodic Maintenance
Other periodic maintenance is listed within the
“ Maintenance & Repair ” section.
Note: Do not use water heater until all needed
repairs have been completed.
Step 2. Check and Fill Burner Fuel Tank
If you are planning to use heated water, check level of
burner fuel tank. If fuel is needed, use #1 or #2 diesel,
B5 or lower biodiesel, kerosene or fuel oil. Use these
precautions each time you fill:
1. Regularly inspect fuel systems for leaks.
2. Fill fuel tank OUTDOORS- never indoors, and stay
away from all sources of heat, sparks and flames.
3. Use an UL approved portable container to transfer
fuel to machine.
Filling Burner Fuel Tank
WARNING: Flammability hazard
Burner fuels are highly flammable. Turn the machine off
and allow it to cool for at least 2 minutes before
removing fuel cap; as a running or still hot burner is hot
enough to ignite fuel.
After Machine Has Cooled:
1. Remove burner fuel cap.
2. Add fuel through the fill opening. Do not overfill.
Allow at least 1/2” of empty space below fill neck
to allow for fuel expansion.
3. Replace fuel cap securely before starting burner.
4. Clean up fuel spills/splashes immediately.

If possible, move the machine away from
spilled fuel on the ground.

Wipe up spilled fuel and wait 5 minutes for
excess fuel to evaporate before starting
burner.

Fuel soaked rags are flammable and should
be disposed of properly.

If fuel is spilled on your skin or clothes,
change clothes and wash skin immediately.
5. Store extra fuel in a cool, dry place in an UL-
approved, tightly sealed container.
Step 3. Select Suitable Worksite Guidelines
WARNING: Location hazard
You must choose a suitable site for operating your
water heater to avoid equipment damage and/or injury
and possible death from carbon monoxide poisoning,
fire/explosion, uncontrolled equipment movement/tip
over, or slips and falls. While designed primarily for
outdoor usage, this electric powered water heater may
be used inside large commercial buildings if special
additional precautions are taken. See below.
Make sure the water heater is on a level surface and in
a protected area where it is not readily influenced by
outside forces such as freezing temperatures, strong
winds, rain, etc. Locate the water heater for easy access
to fill fluids and make adjustments. It is recommended
that a partition is made between the wash area and the
water heater to prevent direct nozzle spray from coming
in contact with the water heater. Excessive moisture will
reduce the water heater’s service life.
Partition
TM