Page:-4 of 6
Q
9
L
H
10
A
M
11
6
AA
R
8
7
Attach to rack using
item F (5/8" x 5.5"L Bolt)
for support prior to installing
weight stack
Attach to rack using
item F (5/8" x 5.5"L Bolt)
for support prior to installing
weight stack
Note:- Pulley(L)need to be removed
and reinstalled at the time of cable
routing to get the cable around the
Pulley(L)- Full tight after cable routing
1. Place 2x Rubber Bumpers (8) over the holes in Base Assembly (5) and slide Guide Rods (6) into them.
NOTE: For improved performance, we recommend you apply a silicone lubricant to the Guide Rods
prior to their installation .
2. Leaning Guide Rods (6) toward you, slide fifteen 15 x Weight Stack (AA) & Selector Shaft (11) onto
the Guide Rods (6) as shown.
3. Slide the Shaft Collars (9) and then the Guide Rod Retainers (Q) onto the Guide Rods(6) as shown.
4. Positon the Guide Rods(6) in the Top Beam(1) and then slide the Guide Rod Retainers (Q) up the
Guide Rods (6) until they rest against the Guide Rod Brackets. Tighten the Set Screw in the Shaft Collars (9).
5
1
