Northern Industrial JPC-80, Руководство пользователя

Страница: 10 / 18

9
6.3 Starting the Engine
1) Shift the engine On/Off switch to
“on”.
2) Open the fuel valve.
Note: If the engine is cold, move the choke lever to
“close” position.
Note: If the engine is hot, set the choke lever at
“open” position.
3) Move the throttle lever slightly to the left.
4) Pull the starter grip gently until resistance is felt, then pull strongly.
Note: If the engine oil level is low, the engine will not start.
Note: If the engine does not run, check the oil level and add oil if needed.
5) Leave the engine run idle for 5 minutes for warm-up.
6) Open the throttle fully to operate plate compactor.
6.4 Stopping the Engine
1) Reduce the engine RPM to idle by moving throttle completely to the right.
2) Shift the engine On/Off switch to
“off” poison.
3) Close the fuel valve.
Please see the instruction manual of engine for further detailed information.
7. Operation
All safety instructions must be read and observed clearly before starting to operate; lack of clarity may
cause troubles of the equipment and cause personal injury.
7.1 Preparation for operation
1) Check all the bolts, nuts and belts. If there is any looseness, tighten it.
2) Check the oil level. If the oil level is low, add fresh oil.
3) Refill the gasoline (Unleaded gasoline).
7.2 Operation