Page of 9
5
1. Using the supplied allen wrench, loosen screws (26) behind the vise fence (23).
2. Rotate the vise fence until the desired angle of cut is aligned with the indicator arrow in th saw
base (14).
3. Check the angle of the vise fence to the cutoff wheel using a protractor, bevel square, or similar
device.
4. Using the supplied allen wrench, securely tighten the bolts holding the vise to the saw base.
QUICK LOCK/RELEASE VISE
The cutoff saw is equipped with a quick lock/release vise system as standard equipment.
With this feature you are able to open and close the vise quickly without excessive turning of the
vise adjustment handle.
USING THE QUICK LOCK/RELEASE VISE
To loosen:
1. Slightly release tension on the Vise (06) by rotating the vise adjustment handle (01)
counterclockwise 1/2 to 1 turn.
2. Lift up the quick Lock/release lever (13) and pull back on vise adjustment handle to slide open
the vise.
To tighten:
1. Push the vise adjustment handle forward to slide the vise against the workpiece.
2. Push down on the quick Lock/release lever to engage its threads with the vise adjusting screw
(03).
3. Rotate the vise adjustment handle clockwise to tighten the vise against the workpiece.
OPERATION:
To start the saw
1. Press the safety on/off button located on the left side of the saw housing (38).
2. While holding the safety on/off button, pull the trigger (49).
To stop the saw
1. Release the trigger completely.
CUTTING
WARNING!
Do not attempt to cut wood or masonry with this saw. Never cut magnesium or
magnesium alloy with this tool. Failure to comply with this warning could result in serious personal
injury.
WARNING!
If wheel stops during operation, makes an odd noise or begins to vibrate,
switch off the tool immediately.
WARNING!
Large, circular, or irregularly shaped material may require additional means of
clamping to be secured in place adequately for cutting. Use C-clamps and blocks to hold material
securely. Failure to comply could result in serious personal injury.
