Read the ENTIRE IMPORTANT SAFETY INFORMATION section at
the beginning of this manual including all text under subheadings
therein before set up or use of this product.
• Press and hold the Power Switch (19) to heat up the Blade (2). The Blade
will reach the pre-set operating temperature in about one minute and will
remain at the temperature selected. Also, the Power ON Light (22) will
illuminate during operation. (See Figure A.)
• When the Blade (2) has reached the pre-set temperature, you may use the
sharp edge of the Blade for line cutting or use the side of the Blade for wide
groove cutting.
• When pressure on the Power Switch (19) is released, power to the Blade (2)
is cut off and the Blade will cool down gradually. (See Figure A.)
WARNING:
The residual heat on the Blade (2) takes several minutes to
dissipate. Use caution while the Blade is still hot.
• Unplug the Hot Knife from its electrical outlet.
• Once the Hot Knife has completely cooled store the tool in a clean, dry, and
safe location out of reach of children and other unauthorized persons.
WARNING:
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL
OPERATION:
Turn the Power Switch (19) of the tool to its “OFF” position and unplug the
tool from its electrical outlet before performing any inspection, maintenance,
or cleaning procedures.
The Adjust The Cutting Depth:
• The cutting depth of the Hot Knife may be adjusted up to 3-3/4in. when using
the Scale Bracket. To adjust the depth, loosen the two Clamping Screws (3).
Pull out or retract the Scale Bracket to the desired cutting depth. Then
retighten the two Clamping Screws. (See Figure A.)
Work Area and Workpiece Set Up:
• Designate a well-ventilated work area that is clean and well-lit. The work
area must not allow access by children or pets to prevent injury and distraction.
• Route the Power Cord (21) along a safe route to reach the work area without
creating a tripping hazard or exposing the Power Cord to possible damage.
The Power Cord must reach the work area with enough extra length to allow
free movement while working.
• There must not be hazardous objects, such as utility lines or foreign objects,
nearby that will present a hazard while working.
General Operating Instructions
• Plug the Power Cord Plug (21) into the nearest 120 volt, grounded,
electrical outlet.
• Turn the Temperature Selector Knob (9) to the desired temperature.
(See Figure A.)
• 1-Level = 0° Fahrenheit
• 2-Level = 248° Fahrenheit
• 3-Level = 527° Fahrenheit
• 4-Level = 725° Fahrenheit
• 5-Level = 842° Fahrenheit
Operating Instructions:
Maintenance And Servicing:
WARNING:
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch (19) of the Hot Knife to its “OFF” position and unplug
the tool from its electrical outlet before performing any inspection,
maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have
the problem corrected before further use.
• BEFORE EACH USE, inspect the general condition of the Hot Knife.
Check for loose screws, misalignment or binding of moving parts, cracked
or broken parts, damaged electrical wiring, and any other condition that
may affect its safe operation.
• AFTER USE, clean external surfaces of the tool with clean cloth.
WARNING!
If the Power Cord (21) of this power tool is damaged, it must
be replaced only by a qualified service technician.
Procedures not specifically explained in this manual must be performed
only by a qualified technician.
7
8