3.1.10
Use the cleaner only with accessories and replacement parts
authorized by the manufacturer. The use of original accessories
and replacement parts will ensure safe, trouble-free operation.
3.1.11
The cleaner must be used standing on a secure, stable surface,
positioned as shown.
3.2 Intended Use
3.2.1
The cleaner is intended only for the cleaning of vehicles,
machines, boats, buildings, etc., by the removal of stubborn dirt
using clean water and chemical detergents.
3.2.2
When using chemical detergents, only use biodegradable types.
We recommend HOBBY – FOAM detergent (#3206).
3.2.3
Only clean vehicle engines in areas in which suitable oil traps
are installed.
3.3 Safety Valve
3.3.1
The safety valve also functions as a pressure-limiting valve.
When the gun trigger is released, the safety valve opens and
the water recirculates through the pump inlet. Never try to
adjust this valve.
Extension cords: up to 50’ = 14AWG; 50’ to 100’ = 12AWG wire required.
4. I
NSTALLATION
/A
SSEMBLY
4.1
Fit the lance into the gun by rotating and pushing until the two
parts are completely locked.
4.2
Connect the gun to the high-pressure hose.
P
ROBLEMS
AND
R
EMEDIES
P
ROBLEM
The pump does not operate at the prescribed pressure.
Sudden changes in pressure.
Excess noise.
Water leakages.
Oil leaks.
Motor does not start
The motor buzzes but fails to start.
TSS MODELS ONLY. Motor starts even though the trigger is released.
TSS MODELS ONLY. No water when lever is operated (when
supply hose is connected).
Power cord damage.
C
A
USE
Nozzle worn or wrong type.
Replace nozzle.
R
EMEDIES
Open the water supply tap fully. Check for nozzle
blockage.
Air being sucked into the system.
Air in pump.
cleaner back on.
Adjustable nozzle incorrectly posi-
tioned.
Pull the spray adjuster back (+)
Water suction from external tank.
Connect the power-jet cleaner to the main water
supply.
Water temperature too high.
Lower temperature.
Nozzle clogged.
Clean with tool provided.
Air being sucked in.
Check water inlet and outlet connections.
Worn seals.
Fit new seals.
Oil seals worn.
Fit new seals.
No electrical power
(§)
and that main power is present. Reset GFCI.
Supply voltage below required
minimum.
Check the voltage of the main supply line.
Voltage loss due to use of extension
cord of inadequate cross-section or
excessive length.
Consult instructions regarding extension cords.
High pressure cleaner in disuse for
extended period of time.
Insert the key in the hole at the rear of the electric
Sealing defects in high pressure system
or water circuit.
Contact nearest service center.
TSS faults.
Contact nearest service center.
Nozzle is clogged.
nozzle.
_______________
Contact nearest service center.
occurs more than once, contact your service center.
More troubleshooting information on our website at www.arnorthamerica.com.
