Nortel NN46120-104, Руководство пользователя

Страница: 54 / 300

54 Initial Setup
6 Enter the Management IP address (MIP) of the existing
cluster.
The system is initialized by connecting to the
management server
on an existing iSD, which must be operational and
initialized.
Enter the Management IP (MIP) address:
<IP address>
Provide the Management IP address of the cluster to which
you want to join the current VPN Gateway. To check the
Management IP of an existing cluster, connect to the cluster and
use the
/cfg/sys/cur
command.
Complete the
join
setup by following the instructions in the
section “Complete the Join Setup” (page 56) .
--End--
Setting up a Two-Armed Configuration
If the currently installed VPN Gateway(s) in the cluster are set up for a
two-armed configuration you probably want the new VPN Gateway to be
set up like the previously installed NVG(s).
To set up a two-armed configuration, proceed as follows:
Step Action
1 Choose join from the Setup menu.
[Setup Menu]
join - Join an existing iSD cluster
new - Initialize iSD as a new installation
boot - Boot menu
info - Information menu
exit - Exit [global command, always
available]
>> Setup# join
Setup will guide you through the initial configuration
of the iSD.
2 Configure the management interface port number.
Enter port number for the management interface [1-4]: 1
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.