Nortel NN10364-301, Руководство по установке и пусконаладке, Страница: 40 / 176

NN10364-301 MCS 5100 3.5 Standard 6.0 December 2006
40
Copyright © 2006 Nortel Networks
Procedure 6 Connecting through the server to the MRV LX
terminal server
At the management pc,
1
Use the following procedure to access the command line
interface port from a dumb terminal attached to an LX Series
serial port, which is set for access local or dynamic:
a Hit the return key several times to autobaud (if autobaud is
enabled) the port and get the login prompt.
b Enter your login name. The default is InReach .
c Enter your password. The default is access .
Procedure 7 Changing the password defaults
At the management pc,
1 The default password for the MRV LX terminal server user is
access . If an unauthorized user knew this username/password
combination, that user could log on to your unit. For this reason,
you should change the user’s password to something other than
access .
The default Superuser password is system . To reduce the risk of
an unauthorized user gaining access to the Superuser
Command Mode, MRV recommends that you change this
password to something other than
system .
To change the user-level password, access the Configuration
Command Mode.
2 Access the Subscriber Command Mode for the subscriber by
entering the subscriber command with
InReach as the
command argument; for example: Config:0 >>subscriber
InReach
3 Enter the password command at the
Subs_InReach >>
prompt.
ATTENTION
MRV Communications recommends that you change the default
password for the user’s MRV LX terminal server before you put
the unit on a network. For more information, refer to
Changing the
password defaults on page 40 .