Nortel Meridian Meridian 1, Планирование, установка и инструкции по эксплуатации

Страница: 193 / 556

Page 174 of 536 Chapter 17 – Connecting the telephones and attendant console
553-3121-210 Standard 3.0 January 1999
4 Press the pound key to select the default extension number.
Relocation tone is heard. The character display shows
“OK”.
or
If the extension number is already in use by another telephone, special
dial tone is heard. The character display shows
“MULTI-LINE, EXTENSION?”.
To accept the default extension number press the pound key.
To select a new extension number, enter an extension number and
press the pound key.
or
If the extension number is not available for use
“ERROR, EXTENSION?“
is displayed and overflow tone is heard. (This happens when the
extension number is entered manually or when extension numbers are
entered for additional keys. A default extension number will not be
offered if it is not available.) Repeat Step 4 and enter a new extension
number.
Note: If other keys require secondary extension numbers, you are
prompted until all the required extension numbers are entered for the
model. These extension numbers cannot be defaulted. The text
display prompting for further extension numbers is
“KEY kk EXT?”
where “kk” represents the key number requiring the extension number.
Each prompt for another extension number is accompanied by special
dial tone. When an extension number is being programmed, the lamp
associated with that number on the telephone is lit.
5 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note: If the handset is replaced before completing the prompt
sequence, the installation will automatically fail. This is useful when an
error is made and the procedure is to be repeated.
—————————— End of Procedure ——————————