Accessing Software Version 3.40 on the Web
204360-D
5
Upgrading your Access Point from Version 3.2x to Version 3.40
To upgrade from Software Version 3.2x to Software Version 3.40, you must use a
10BASE-T network. If you do not use a 10BASE-T network, the software
upgrade process does not allow you to upgrade your BayStack 600 Series
Wireless LAN products.
Refer to the appropriate README file and the documentation for installation
procedures.
The recommended procedure for upgrading to Software Version 3.40 is:
•
Install the BayStack AP Manager Version 3.40.
•
Update the access point firmware to Version 3.40.
•
Update the PC Card firmware to Version 3.40.
Upgrading Your PC Software from Version 3.2x to Version 3.40
Refer to the README files for the appropriate driver and documentation for
instructions to install the new version of the software.
To upgrade the PC card in your laptop to Version 3.40 software:
•
Run Setup.exe to install the 3.40 version drivers and utilities.
Upgrading Your PC Card Firmware from Version 3.2x to Version 3.40
Refer to the appropriate PC Card firmware README files and documentation for
instructions to install the new version of the software.
To upgrade the PC card in your laptop to Version 3.40 software:
•
Run aspflash.exe (in the DOS command prompt safe mode) to install the
3.40 version drivers and utilities.
You must restart your computer to perform this operation.
Book.fm Page 5 Thursday, October 14, 1999 4:33 PM