Nortel BayStack 450 Switch, Руководство по установке

Страница: 76 / 142

76 LAN connection
Nortel Business Communications Manager 450 1.0
Installation — System
NN40160-301 01.04 Standard
July 2009
Copyright © 2006-2009 Nortel Networks
LAN connection navigation
• Connecting the main unit to the LAN (page 76)
• Connecting IP devices to the LAN (page 76)
Connecting the main unit to the LAN
Connect your BCM450 main unit to the LAN to enable LAN access for your
system.
Prerequisites
• Obtain a standard Ethernet cable.
• The DHCP server on the main unit is enabled (IP Phones only) by default.
If your network already contains a DHCP server, disable the DHCP server
on the main unit.
Procedure steps
Step Action
1 Connect one end of a standard Ethernet cable to your LAN.
2 Plug the other end of the Ethernet cable into one of the available two LAN
ports on the BCM450 main unit (two right-most ethernet ports).
The OAM port does not support VoIP devices.
--End--
Connecting IP devices to the LAN
Connect IP devices to the LAN to provide additional functionality to your
BCM450 system.
Prerequisites
• Obtain a standard Ethernet cable for each IP device.
• A properly configured layer 2 switch in the network.
CAUTION
The two LAN ports on the BCM450 are set up in a bridge
configuration (both ports use the same IP address). Do not connect
IP devices to both ports at the same time to avoid service problems.