Nortel 425-24T, Руководство по настройке, Страница: 124 / 488

124 Chapter 3 CLI Basics
320985-A Rev 01
Port numbering in standalone mode
In a standalone mode, the port number variable is an integer between 1 to 50 for
Ethernet Switch 425-48T and 1 to 26 for Ethernet Switch 425-24T. You can use
the
<portlist>
variable in the following formats:
• A single port number—an integer between 1 to 50.
— Example:
7
means port 7
• A range of port numbers—a pair of port numbers between 1 and 50 separated
by a dash.
— Example:
1-3
means ports 1, 2, and 3
— Example:
5-24
means all ports from port 5 through port 24
• A list of port numbers and/or port ranges, separated by commas.
— Example:
1,3,7
means ports 1, 3, and 7
— Example:
1-3,9-11
means ports 1, 2, 3, 9, 10, and 11
— Example:
1,3-5,9-11,15
means ports 1, 3, 4, 5, 9, 10, 11, and 15
•
none
means no ports.
•
all
means all the ports on the standalone Ethernet Switch 325/425, including
any GBIC ports.
You can also use the unit/port convention discussed in “Port numbering in stacked
mode” , with a standalone Ethernet Switch 325/425 as long as the unit number is 1.
Port numbering in stacked mode
In Ethernet Switch 425-24T Stack mode, use the
<portlist>
variable to
represent the number of the unit within the stack, followed by a forward slash (/),
and the port number(s). Unit number will always be an integer between 1 and 8,
and the port numbers will always be integers between 1 and 25. You can also use
none
to indicate none of the ports in the stack or all to indicate
all
of the ports in
the stack.
In the Stack mode, use the
<portlist>
variable in the following formats:
• A single port number—an integer for the unit, followed by /, and an integer
for the port number
— Example:
1/7
means unit 1 port 7