Nortel 4050, Руководство по установке

Страница: 29 / 46

Chapter 2 Installation Process 29
Nortel Secure Network Access Switch 4050 Installation Guide
Terminal requirements
To establish a connection with a Nortel Secure Network Access Switch 4050, the
following requirements are necessary:
• An ASCII terminal or a computer running ASCII terminal emulation software
with the parameters shown in
Table 6 .
• A console cable, male to female, with DB-9 connectors and 1 to 1 connections
(shipped with the Nortel Secure Network Access Switch 4050).
Console connector and pin assignments
The console port on the unit is a DCE female DB-9 connector. Table 7 describes
pin signal and I/O assignments for this connector.
Table 6 Console configuration parameters
Parameter Value
Baud Rate
Data Bits
Parity
Stop Bits
Flow control
9600
8
None
1
None
Table 7 Pinouts for DB-9 console connector
DB-9 Console Port Connector Pin Signal I/O Description
1
2
3
4
5
6
7
8
9
Shell DCD
RXD
TXD
DTR
GND
DSR
RTS
CTS
RI
N/A O
O
I
I
N/A
O
I
O
O
N/A Data carrier detect
Received data
Transmitted data
Data terminal ready
Signal ground
Data set ready
Request to send
Clear to send
Ring indicator
Chassis ground