90
Configure an E1/T1 card
Table 20
PRI2/Euro D-channel interface configuration (LD 17)
Prompt
Response
Description
REQ
CHG
Change existing data.
TYPE
ADAN
Action device and number.
ADAN
NEW DCH xx
Add a D-channel on logical port 0 - 254.
CTYP
MSDL
D-channel configuration on MSDL card.
MSDL= NTBK51AA/NTBK51CA downloadable D-channel
daughterboard.
TMDI is not supported for the PRI Gateway.
MG_CARD
supl sh card
The physical card for the digital loop association to the PRI
Gateway.
The format is: superloop, shelf number, card number.
ATTENTION
Even card numbers are applicable (2, 4, 6, 8).
PORT
0 - 1
Port number of the NTBK51AA/NTBK51CA for the
D-channel.
USR
PRI
This D-channel is used for Primary Rate only.
IFC
EURO
Interface type for the D-channel.
CNTY
aaaa
Country
...
...
DCHL
0 - 254
Loop number for the D-channel. (See PRI2 loop number.)
SIDE
(USR) NET
The system is network/user side.
...
...
--End--
Use
Procedure 21 “Configuring DPNSS/DASS D-channels in the PRI
Gateway using LD 17” (page 90)
to configure the DPNSS D-channel
interface in the PRI Gateway.
Procedure 21
Configuring DPNSS/DASS D-channels in the PRI Gateway using LD 17
Step
Action
1
Log on to the CS 1000E.
2
To access LD 17, enter:
LD 17
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01
4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.
Содержание 1000E PRI
Страница 161: ......