120
Configure an E1/T1 card
Procedure 46
Configuring basic parameters for an E1/T1 card through the Web
Step
Action
1
On the Home - System Overview screen, select System
Settings > Basic Setting.
The window shown in
Figure 33 "System Settings - Basic
appears.
Figure 33
System Settings - Basic Settings window
The IP address was previously defined through a CLI command
as shown in
“Configure LAN parameters” (page 108)
2
In the MGC IP address field, type the IP address of the Media
Gateway Controller.
The E1/T1 card uses this address to receive the time and date
from the Media Gateway Controller.
3
In the System Name field, type up to 15 alphanumeric
characters for the name of the system.
4
In the IP address of E-mail Server field, type the IP address.
The E1/T1 card uses this address to send system backup files.
If this field is left empty or is incorrect, the E1/T1 card does
not send e-mail messages. However, the rest of the system
operates properly.
ATTENTION
The E1/T1 card uses SMTP. The e-mail server must support this
protocol.
5
In the From E-mail address field, type the e-mail address
that the E1/T1 card uses to identify itself (the default is
[email protected]). This is the e-mail address that appears in
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01
4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
.
Содержание 1000E PRI
Страница 161: ......
