Quick Start Guide
2
Configuration
The HDBaseT outputs can be configured via the PC control software or a terminal emulator connected
to the RS232 or Ethernet ports on the unit. The interface supports all the principal HDMI resolutions
and frame rates, as well as embedded audio and HDCP.
Example of PC Control screen shown here
Connection
The card has two independent HDBaseT outputs and a single LAN input, supporting 100BaseT. Good
quality CAT6 screened cable is recommended, with the cable screen connected at both ends. Reliable
transmission up to 100m can be achieved in these circumstances, (though not all receivers support
CAT6 cabling). The CAT6 cable should be routed away from electrically noisy cable or other sources of
interference such as electric motors, wherever possible.
Unscreened CAT6 or CAT5e may be usable over shorter distances.
The indicator under each HDBaseT connector signify the following:
Solid green
=
cable terminated
Solid amber =
HDCP source
Flashing amber =
Non HDCP source
1 x LAN input supporting up to 100BaseT
Troubleshooting
If you experience any problems with this module, please refer in the first instance to ‘Tech Support’ on
the TV One web site.
