ITP-8
9
12V DC Power Supply
By using a 12V DC power supply (not included) to power the ITP-8 you can
provide power locally or remotely. If powering locally, be sure to run the wire
through the wall in accordance with local building and electrical codes.
If powering remotely, be sure to use wire of adequate gauge for the length
of the run.
Verify the polarity of your power supply prior to termination and ensure the
power supply is not connected to a power source.
Strip approx. ¼” of insulation from the wire, and observing the correct
polarity, terminate the wire into the supplied connector and tighten firmly.
Be sure to twist the wires before inserting so that no strands escape the
connector. Inspect the termination to verify that the wire is securely retained
by the connector and no strands have escaped the barrier.
Plug the connector into the ITP-8.
PoE Network Switch
F-1-A
To ITP-8
PoE Injector
Network Switch
