1
WT00Z-1 WALL MOUNTED TRANSMITTER
The GoControl™ family of Z-Wave® certifi ed wireless lighting products
(smart LED fi xtures, bulbs, switches, dimmers, outlets, plug-in modules, and
thermostats) and security devices (alert sounder, motion sensor, and door/
window sensor) bring a new level of intelligent wireless capability to commercial
and residential environments.
The Z-Wave wireless protocol is an international wireless standard for remote
home automation, security and other applications. This product can be included
and operated in any Z-Wave network with other Z-Wave certifi ed devices
from other manufacturers and/or other applications. All non-battery operated
nodes within the network will act as repeaters regardless of vendor to increase
reliability of the network.
GoControl Z-Wave products are easy to install, are Z-Wave certifi ed, and allow
dealers to create an integrated wireless network with nearly limitless expansion
and interoperability with security, energy management, home entertainment,
appliances, and more.
DANGER! SHOCK HAZARD.
Read and understand these instructions
before installing. This device is intended for installation in accordance with
the National Electric code and local regulations in the United States, or the
Canadian Electrical Code and local regulations in Canada. It is recommended
that a qualifi ed electrician perform this installation. For indoor use only. Retain
instructions for future use.
INSTALLATION
Wire this switch in place of a current wall switch according to the diagram
above.
✓
CAUTION!
Do not wire unit “live” (with power on the circuit).
Adding to a network:
Refer to your Controller operating instructions to add this switch under the
command of the Wireless Controller.
1.
With your Controller in Discovery or Add Mode, tap the switch once for
Network Wide Inclusion. Tap twice for Standard Inclusion.
2.
You should see an indication on your Controller that the “device was added”
to the network and the LED will stop blinking.
3.
The device will appear in the list of Switches. It should display as a switch.
Removing from a network:
The WT00Z-1 can be removed from the network by the Controller/Gateway.
Refer to the Controller operating instructions for details.
1.
Set the Controller into Removal Mode and follow its instruction to delete the
WT00Z-1 from the Controller.
2.
Remove the switch by tapping the paddle 2 times.
3.
You should see an indication on your Controller that the “device was
removed” from the network.
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,WT00Z-1,GO CONTROL; P/N: 10008608 X5; INK: BLACK; MATERIAL: 20# MEAD BOND; SIZE: 8.500” x 11.000”; TOLERANCE ± .125”; SCALE: 1-1
WT00Z-1
Z-Wave Radio Frequency (RF) Controlled, 120 VAC
Scene and NWI Capable, Wall Mounted Transmitter, Series 300
NEUTRAL
120 VAC
PUSH ON (PUSH
& HOLD TO BRIGHTEN)
WHITE
LINE
BLACK
PUSH OFF
(PUSH AND
HOLD TO DIM)
STATUS LED
GREEN GROUND
TAP TOP OR BOTTOM
OF SWITCH PADDLE
TO CONFIGURE
TO MOUNT MORE THAN ONE
WT00Z-1IN A BOX, SCORED TAB
WILL BREAK FLUSH WITH EDGE
OF PLASTIC
Shown with supplied
decorative trim plate
NOTE:
This unit must be added to the Network
only where it will be permanently installed.
The proper operation of this node in the
mesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” confi gure this unit, then install.
