Nortek Security & Control | 1950 Camino Vida Roble, Suite 150 | Carlsbad, CA 92008-6517 | USA | 800-421-1587 | www.nortekcontrol.com
Copyright © 2016 Nortek Security & Control LLC.
1
Installation Instructions
Introduction
The 2GIG Vario Wireless Receiver is a flexible unit that can be used either as a
wireless receiver when connected to the security panel or as a stand-alone
receiver, with support for 2GIG sensors.
Main Features
Up to 32 supervised wireless zones
Up to 16 multi-function keyfobs
Two utility outputs
Signal jamming detection
Threshold-level calibration
Tamper detection
Transmitter supervision low battery detection
Low battery detection
Nominal center frequency: 345 MHz
Mounting Considerations
Do not install the receiver close to metal objects and RF generating
devices such as TV sets or computers.
Mount the receiver at a height of at least 1.5 m (5 ft) above the floor.
Wall Mounting
1.
Screw cap
2.
Upper mounting hole
3.
Lower mounting holes (optional)
4.
Wall tamper hole
Figure 1. Rear Panel
1.
Separate the mounting bracket from the main unit.
2.
Use the mounting bracket as a marking template.
3.
Tear off screw caps, as needed for covering front screw hole.
4.
Mount the bracket to the wall.
Wiring the Receiver
1.
Optional screw hole (used to
fasten front and back covers)
2.
Red LED
3.
Green LED
4.
Prog button
5.
DIP switch
6.
Box tamper
7.
BUS connector
8.
Terminal block
Figure 2. Receiver Layout (Cover Off)
Terminal
(Left to Right)
Description
AUX Red
+13.8V power VDC (in BUS connection, connect to
AUX on the control panel)
Com BLK
Black 0V common (in BUS connection, connect to
COM on the control panel)
BUS YEL
Data BUS connection (Not for Stand Alone mode)
BUS GRN
Data BUS connection (Not for Stand Alone mode)
Relay 1 N.O
For Future Use
Relay 1 COM
Relay 1 N.C.
Relay 2 N.O.
For Future Use
Relay 2 COM
Relay 2 N.C.
NOTE:
The maximum wire run permitted is 300 meters (1,000 ft)
for the total BUS wiring regardless of the wiring gauge used.
When closing the cover, use a screw cap loated on the rear side to
cover the closing screw.
BUS Mode
(SWB in OFF position)
SW1–SW3
Three switches to set ID of the receiver
SW4–SW6
For Future Use
SW7
Utility Output Receiver Enable/Disable
OFF: Disable
ON: Enable
SW8
For Future Use
DIP Switch Settings
2GIG® Vario System
2GIG Vario Wireless Receiver
10012335 A
