NORPOLE NPRAC10KEWMZ1, Руководство пользователя

Страница: 23 / 60

23
DIRECTIONAL AIR LOUVERS
The louvers will allow you to direct the air
Left or Right. Pivot horizontal louvers until
the desired Up/Down direction is obtained.
Move the Levers from side to side until the
desired Left/Right direction is obtained.
Figure 27
Levers
CAUTIONS
:
• The air conditioner will not operate if curtains, doors or other materials block the signals from the
remote controller to the unit.
• Prevent any liquid from falling into the remote controller. Do not expose the remote controller to
direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may
not function properly. Use curtains to prevent the sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller, either move these appliances or consult
your local dealer.
NOTE
:
• Buttons design is based on typical model and might be slightly different from the actual one you
purchased, the actual shape shall prevail.
• All the functions described are accomplished by the unit, if the unit has no this feature, there is no
corresponding operation happened when press the relative button on the remote controller.
• When there are wide differences between Remote controller Illustration and USERS MANUAL on
function description, the description on USERS MANUAL shall prevail.
• The device could comply with the local national regulations. In Canada, it should comply with CAN
ICES-3(B)/NMB-3(B). In USA, this device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
◦ Reorient or relocate the receiving antenna.
◦ Increase the separation between the equipment and receiver.
◦ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
◦
not approved by the party responsible for compliance could void suers authority to operate the
equipment.