9
Figure 10
•
After 5 seconds, the system will revert back to showing the humidity level on the display.
•
When the Auto start & Auto stop times are both set within the same program sequence,
TIMER
ON and OFF indicator lights illuminate identifying both ON and OFF times are now programmed.
•
Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the Auto
Start/Stop timer program.
•
If the P2 code occurs, the Auto Start/Stop program will be cancelled.
f. + and - (Humidity Set Control Buttons): The humidity level can be set within a range of 35% RH
(Relative Humidity) to 85% RH in 5% increments. The lower the set % is, the drier the air will be.
g. Indicator Lights
•
Filter – Filter needs to be cleaned
•
Full (Bucket full light) – Empty water bucket
•
Cont. - Continuous dehumidifying light
•
On (Timer on light) – Auto On/Start set.
•
Off (Timer off light) – Auto Off/Stop set
•
Turbo - High fan light
•
Normal - Low fan light
•
Auto Defrost - Auto defrost on
h. LED Display: Displays the relative humidity level for the room (±5%) within a range of 30%-90%.
While setting, displays the set level for humidity between 35%-85%, or the auto start/stop time
(0~24), along with error or protection codes.
Error Codes
•
AS: Humidity Sensor error
•
ES: Temperature sensor error.
•
EC: Refrigerant leakage (on models with this feature)
Protection Code
•
P2: Water bucket full or incorrectly
installed.
NOTE
: If the display shows one of the above codes turn off and unplug the unit, and check for any
obstructions or empty the water tray, then restart. If code is still present, turn off again and unplug,
and contact customer service or service technician for assistance.
SMART FUNCTIONS
•
Auto Shut Off: When the water “Full” indicator light turns on or the humidity setting is reached, the
unit will be shut off automatically.
•
Delayed Start: When the unit has stopped or power is interrupted, it will not restart 3 minutes to
protect the cooling system. The dehumidifier will automatically start after 3 minutes have passed.
•
Auto Defrost: When frost builds up on the evaporator coils, the compressor will cycle off and the fan
will continue to run until the frost melts.
•
Auto-Restart: If the power is lost or cut, the unit will restart with the previous function setting
automatically when the power resumes.
DRAINING WATER
There are two ways to remove water
collected while the dehumidifier is
running.
1.
Manually empty the water bucket:
When the bucket is full, remove
from the back of the unit and
empty.
Water Outlet
