background image

6

• Select Program by pressing the Program button. The program

number will flash. 

• Use the (+) or (-) buttons to select your program number 

(i.e., 1, 2, 3, etc.).

Program button

1

Program Number

• The main menu screen for Home will automatically appear. 

If you’re lost at any point, just hit the Foot Pedal once to
return to the Home screen.

Main Menu 

4

TIP

Programmed Dispense Mode

5

• For initial setup, make sure you’re in Programmed Dispense mode.

When you’re in Programmed Dispense, the LED light left of the
Manual/Program select button is not lit. 

To select Programmed Dispense mode, press the “hand” icon
so the red light is off. 

TIP

1

Home     Jog

Hand icon  

Red Light 

OFF = Program

(Red Light On = Manual)

2

Connect Power & Foot Pedal

3

• Connect the power cord provided to the back of the Ultimus IV and

plug into your power source. 

• Connect the foot pedal provided to the back of the Ultimus IV. 

• Turn unit on; On switch is located at the back of the unit. An “EFD

2800” screen will briefly appear before the Main Menu comes up.

Power cord

Foot pedal

On/Off

7

• Select Volume by pressing the Forward button. 

• Use the (+) or (-) buttons to set your deposit volume. 

Note: The maximum number of Forward steps is 65,534.

Deposit volume, measured in cc’s, is linked automatically to 
forward steps of the stepper motor. When you increase your cc
setting, it automatically increases the number of forward steps.

TIP

Forward button

Deposit Volume

Содержание Ultimus IV

Страница 1: ...he forward or rear position on either side Remove barrel holder sleeve from holder Insert the 6 mm screw through the barrel holder and bracket and then into the top hole of the front mounting block Tighten screw to secure Insert barrel holder sleeve Part B Install Cable Guide Insert thumbscrew through both the cable guide mount and star washer and then into other mounting block π Position flex arm...

Страница 2: ...red light is off TIP 1 Home Jog Hand icon Red Light OFF Program Red Light On Manual 2 Connect Power Foot Pedal 3 Connect the power cord provided to the back of the Ultimus IV and plug into your power source Connect the foot pedal provided to the back of the Ultimus IV Turn unit on On switch is located at the back of the unit An EFD 2800 screen will briefly appear before the Main Menu comes up Powe...

Страница 3: ...the syringe barrel and hold barrel next to the flexible cable assembly From Manual mode hand icon light on advance the plunger by pressing the Forward button just until the plunger reaches past the piston By hand insert the plunger into the barrel pressing it into the piston Press the Pullback button to retract barrel until there is just a small gap between barrel and adapter Slide barrel retainer...

Страница 4: ...els or cartridges to a temperature greater than 100 F 38 C Dispose of components according to local regulations after one time use Do not clean components with strong solvents e g MEK Acetone THF Cartridge retainer systems and barrel loaders should be cleaned with mild detergents only To prevent fluid waste use Nordson EFD SmoothFlowTM pistons For Nordson EFD LLC sales and service in over 30 count...

Отзывы: