Nordson Smart Gun, Руководство пользователя по изделию

Страница: 15 / 48

© 2021 Nordson Corporation
7446567-02
4-1 Installation
Section 4
Installation
It is imperative to follow the safety instructions outlined in this manual. Refer to
Safety
for
additional information. Contact a Nordson® representative regarding these procedures (if
necessary).
WARNING:
• Safety glasses are to be worn at all times while installing, servicing, operating, or
observing equipment. The sudden release of air or fluid can cause damage to eyes.
• Allow only qualified personnel to perform the following tasks. Follow the safety
instructions in this document and all other related documentation.
• Do not remove any covers during operation. The moving parts under these covers
could cause injury to personnel.
• Relieve system and material pressure before disconnecting hoses.
•
Shut off and lock out power to the smart gun prior to installing smart gun to robot.
• Never exceed the maximum operating temperature of 180 ̊F (82 ̊C).
WARNING: Any material injected into flesh can cause severe injury or death. Keep
body parts away from material discharge ports. If injection occurs, seek medical attention
immediately.
WARNING: Operating faulty electrostatic equipment is hazardous and can cause elec-
trocution, fire, or explosion. Make resistance checks part of your periodic maintenance
program. If you receive even a slight electrical shock or notice static sparking or arcing,
shut down all electrical or electrostatic equipment immediately. Do not restart the equip-
ment until the problem has been identified and corrected.
CAUTION:
• Relieve air and material pressure when equipment is not in use for prolonged periods
of time. Do not allow pressure to remain static when equipment is idle as this may
cause material to pack and harden.
• Do not use silicone based lubricants with a smart gun. The use of silicone based
lubricants can promote seal failure.