Nordson R3V, Руководство по эксплуатации

Страница: 41 / 146

RV Series Automated Dispensing Systems
41 www.nordsonefd.com info@nordsonefd.com +1-401-431-7000 Sales and service of Nordson EFD dispensing systems are available worldwide.
Setup
After installation and before creating any programs, perform these required and optional setup procedures as
applicable for your automated dispensing system.
Setting System Parameters
The factory system settings are appropriate for most applications. Use this procedure as needed to view or change
system settings. Important system settings include the following:
•
Speed:
The speed at which the dispensing tip moves.
• Line Acc: How the robot accelerates from one point to another.
To View or Change System Parameters
#
Click Step Reference Image
1
>
• Click the SYSTEM SETUP tab, then click
OPEN.
2 • View or change parameters as appropriate for your application. Refer
to “System Setup Screen Fields” below for information on system-level
parameters.
3 • Click another tab to close the System Setup screen.
NOTE: Settings are automatically saved except for the Model and Language
selections. Changes to these selections take effect after you EXIT and reopen
the DispenseMotion software.
System Setup Screen Fields
NOTE:
Default values may vary depending on the selected robot model.
Item Screen Capture Description
Axis Limit Sets the range limits within which the robot can move. A value higher
than the default settings cannot be entered.
Speed Sets the speed (in mm/s) of the axis movement. For maximum speed
specifications, refer to “Specifications” on page 12.
NOTE:
You can also change the jog speed settings by clicking the 2 next
to the navigation and jogging window. Refer to “Navigation and Jogging
Window” on page 34 for detailed information.
CAUTION
The robot automatically adjusts its speed depending on the complexity
of the pattern. Forcing the robot to run at higher speeds can compromise
accuracy and may disrupt system operation.
Continued on next page