Nordson Encore XL Powder, Руководство пользователя

Страница: 54 / 155

© 2021 Nordson Corporation
1607027-01
5-2 Operation
Controls
1 2 3
4 5 6
11
10 9 8 7
13
12
Figure 5-1 Feed Center Controls
Control Function
1. Waste Pumps
When on and the exhauster is running, the transfer pumps are turned on to move powder
from the feed center collector to a scrap hopper.
2. Bulk Feed Pump
Turns the virgin powder transfer pump on and off. Used when system is equipped with
a bulk feed system. When on, the pump is turned on and off automatically as needed to
satisfy the level sensor on the lance assembly.
3. Reclaim Powder Transfer
Pump
Turns the reclaim powder transfer pump on and off. When on, the pump operates
continually.
4. Sieve Control Turns sieve vibrator motor on and off.
5. Color Change Enable
Starts color change sequence. If operator platform is equipped with an Ancillary
Equipment Clean Cycle button, lances are automatically raised out of the hopper or box. If
not, then it starts external gun blow off.
6. Emergency Stop Shuts down powder coating system.
7. Table Vibrator Turns table vibrator motor on and off.
8. Purge Selection
Left: Start internal gun purge cycle.
Center: Off
Right: Start transfer pump purge cycle.
9. Lance Lift Raises and lowers lance assembly.
10. Powder Source Select Selects hopper or box, controls where lances stop when lowered into powder.
11. Color Change Indicator
Light (Green)
Off: Color change cycle is disabled
Blinking: In color change cycle.
On: Color change automatic operations complete.
12. Exhaust Fan Turns exhaust fan on and off. Switch will illuminate when On.
13. Final Filter Fault
Indicator
Off: Normal operation, no fault.
On: High pressure sensed by final filter sensor. Exhaust fan will turn off.