Nordson Asymtek Spectrum S-920, Инструкция по установке, эксплуатации и обслуживанию

Страница: 86 / 238

4-20 Power-Up and Testing
To check Board Sensor operation:
"
NOTE This procedure assumes the following:
•
Each conveyor station has a board sensor that is positioned to sense
the workpiece.
•
The conveyor rail width has been adjusted to fit a production sample workpiece.
Perform this procedure as applicable to the configuration of your dispensing system.
1. Open the dispensing system hood.
2. Place a production sample workpiece on the conveyor to the left of the dispense station board
sensor.
3. In the Conveyor I/O Diagnostic dialog box (Figure 4-14), locate the board sensor inputs.
Figure 4-14 Conveyor I/O (Inputs 0-31)
4. Manually move the workpiece under or over (depending upon system configuration) the
dispense station board sensor and monitor the dialog box
SENSOR_CTRA
input.
!
The
SENSOR_CTRA
input should change from
OFF
(
0
) to
ON
(
1
).
5. Move the workpiece out of Board Sensor sensing range and monitor the dialog box
SENSOR_CTRA
input.
!
The
SENSOR_CTRA
input should change from
ON
(
1
) to
OFF
(
0
).
6. Repeat Steps 4 and 5 for the pre-dispense station and post-dispense station, as applicable.