Nordson Asymtek Spectrum S-920, Инструкция по установке, эксплуатации и обслуживанию

Страница: 80 / 238

4-14 Power-Up and Testing
4.10.4 Light Beacon
Perform the following procedures to check function of the Light Beacon.
To test the Light Beacon:
1. Close the dispensing system hood, make sure the EMO is deactivated, and press the green
ON
(
l
) button on the front panel.
!
The green beacon light should be ON.
2. Open the hood.
!
The yellow beacon light should come ON and the green beacon light should go OFF.
3. Close the dispensing system hood.
!
The green beacon light should come ON and the yellow beacon light should go OFF.
4. In the FmXP Main Window, click on
Tools
.
5. In the Tools Window, click on
I/O Test
.
6. Click on
Dispenser .
!
The I/O Test Dialog screen opens.
7. Locate the tab (Figure 4-10) with the beacon color outputs (
BEACON_YELLOW
, etc.).
8. Make sure the
SOFTWARE_ACTIVE
bit is
ON
(
l
). If not, the beacon lights will not toggle.
Figure 4-10 Dispenser I/O (Outputs 32-63)
9. Toggle the button next to the desired output
ON
(
l
) and
OFF
(
0
) to test the beacon signal.
10. Click on
OK
to return to the Tools Window.
11. Click on
Main
to return to the Main Window.