Safety
2-1
2 Safety
2.1 Overview
This section is intended to provide basic safety information necessary for operating and servicing the
Spectrum S-920 Series Dispensing System. This section covers the following topics:
•
•
•
Basic Safety Precautions and Practices
•
•
Lifting and Transport Precautions
•
•
•
•
•
To further optimize safe dispensing system operation, precautions and recommended practices are
included with the procedures throughout this manual.
WARNING!
CAUTION!
Unsafe equipment conditions can result in personal injury or property damage.
Failure to properly operate and maintain the system in accordance with this
manual could cause the built-in safety features to be ineffective.
"
NOTE
Safety is considered a joint responsibility between the original equipment manufacturer
(Asymtek) and the end-user (owner). All safety precautions and practices should be in
accordance with local regulations and facility policy.
2.2 Facility
Requirements
To ensure optimal performance and safety, it is necessary to install the dispensing system in a facility that
meets the necessary requirements. See
. If you have any questions, please
contact Asymtek Technical Support.
2.3 Intended
Use
Use of Asymtek equipment in ways other than those described in the documentation supplied with the
equipment may result in injury to persons or damage to property. Some examples of unintended use of
equipment include:
•
Using incompatible materials
•
Making unauthorized modifications
•
Removing or bypassing safety guards or interlocks
•
Using incompatible or damaged parts
•
Using unapproved auxiliary equipment
•
Operating equipment in excess of maximum ratings
Содержание Asymtek Spectrum S-920
