Electrical connection
Your washing machine is set to 220-240V and 50Hz.
Mains cord of your washing machine is equipped with a specific
grounded plug. This plug should always be inserted to a grounded
receptacle of 10 amperes. Fuse current value of the power line
connected to this plug should also be 10 amperes. If you don’t
have such a receptacle and fuse confirming with this, please have
it done by a qualified electrician.
We do not take the responsibility of the damages that occur
due to ungrounded usage.
Operating your machine under low voltage will cause the life cycle
of your machine to be reduced and its performance to be
restricted.
Water inlet connection
Your machine may have either a single inlet (cold) or double water
inlets (cold/hot) based on its specifications. White-capped hose
should be connected to cold water inlet and red-capped hose to
hot water inlet (applicable for machines with double water inlets).
To eliminate water leakages in points of contact, 1 or 2 nuts are
provided in the hose package (applicable for machines with double
water inlets). Fit these nuts to the ends of new water inlet hoses on
the side of faucet.
Connect the white-elbow end of the water inlet hoses to the white-
filtered water inlet valve on the rear side of the machine and the
red-elbow end to red-filtered one (applicable for machines with
double water inlets). Tighten plastic parts of the junctions using
your hand. In uncertain conditions, have the connection works be
done by a qualified plumber.
Flow of water with pressure of 0.1-1 Mpa will allow your machine to
operate more efficiently (0.1 Mpa pressure means that more than 8
litres of water will flow through a fully-tapped faucet per one
minute).
Ensure that points of contact do not leak by tapping the faucet
completely after carrying making the connections.
Ensure that new water inlet hoses are not folded, broken, crushed
or their dimensions are not altered.
Mount new water inlet hoses to a ¾ , threaded faucet.
If your machine has double hot water inlets, the temperature of hot
water inlet should be maximum 70°C.
10
CHAPTER -3: SETTING UP
ELECTRICAL CONNECTION / WATER INLET CONNECTION
