Nordmann Engineering SPA Display, Инструкция по установке и эксплуатации

Страница: 12 / 36

12
3. Insert the in-wall mounted housing into the wall opening, align it with the help of a spirit level, then fix
it with the four fastening claws attached to the in-wall mounted housing (only necessary with cavity
walls).
Note: in massive walls the in-wall mounted housing must be fixed either with the screws and dowels
supplied or by using PU mounting adhesive or mortar.
Fig. 7: Mounting the in-wall mounted housing to the wall opening
4. Free the shielding of the CAN BUS cable(s) by removing the insulation from the appropriate clamp-
ing position to the end of the cable. Remove the exposed shielding to about 2 cm, then fix the end
of the remaining shielding with a piece of shrink tubing as shown in Fig. 8 and secure the exposed
shielding with the shielding clamp(s) to the housing.
Stripped-down shielding
shrinkable tubing
Cable wires
Fig. 8: Fix the CAN BUS cable(s) with exposed shielding to the housing with the shielding clamp(s)