23
HOW TO OPERATE THE REMOTE CONTROL
The first time you use the re-
mote control, insert batteries
(see HOW TO CHANGE THE
BATTERIES IN THE REMOTE
CONTROL at the right).
Next, stand on the treadmill and
hold the remote control near the
television. Point the remote con-
trol directly at the television.
Press the power button ( ). After a few moments, the
television will turn on or turn off.
Press the Volume (VOL) increase or decrease button
to adjust the volume. For best results, change the vol-
ume by pressing the Volume buttons on the console
only. The Volume increase and decrease buttons on
the remote function as the left and right navigation but-
tons in a menu.
Press the Mute button to turn on or turn off the sound.
Press the numbered channel buttons or the Channel
(CH) increase or decrease button to select a channel.
The Channel increase and decrease buttons on the re-
mote also function as the up and down navigation but-
tons in a menu.
Press the Return button ( ) to view the previous
channel.
Press the Menu button to view the main menu or to
view a previous menu. See pages 24 and 25 for infor-
mation on the menu.
Press the Exit button to exit any menu.
Press the PRLIST button to view a list of channels. If
you have labeled any channels, the menu will also
show the channel label. See page 25 for information
on labeling channels. Note: You can also view this list
by pressing the PRLIST button on the console.
Press the EPG button to view the electronic program
guide. Note: The electronic program guide is only
available when viewing ATSC digital television.
Press the Info button to view information about the cur-
rent program and the broadcast or cable signal.
Press the CC button repeatedly to turn on or turn off
closed captioning. See step 5 on page 24 to adjust
closed captioning settings.
Press the TV/AV button repeatedly to select the input
source. To view television channels through an an-
tenna or a CATV cable, select the TV source. To use
the 96" A/V Wire, select the AV source.
Press the MTS button repeatedly to select mono,
stereo, or SAP (secondary audio programming) as the
audio setting.
Press the Format button repeatedly to select auto, 4:3,
or wide image as the display format. Note: The auto
display format is only available when viewing ATSC
digital television.
Press the Pict button repeatedly to select standard, dy-
namic, soft, or personal as the image mode.
Press the Audio button repeatedly to select standard,
music, movie, or personal as the audio mode.
To select a sub channel, select a channel, press the
Subchannel button ( ), and then press the numbered
channel buttons.
HOW TO REPLACE THE BATTERIES IN THE
REMOTE CONTROL
To replace the batteries,
first locate the battery
cover on the back of the
remote control. Push
down lightly on the bat-
tery cover with your
thumb and slide off the
battery cover.
Next, remove the old batteries from the remote control,
and insert two new “AAA” batteries.
Make sure to in-
sert the batteries as shown in the drawing
. Then,
slide the battery cover onto the remote control.