28
SYMPTOM: The walking belt is off-center or slips
when walked on
a.
If the walking belt is off-center,
first remove the
key and
UNPLUG THE POWER CORD. If the
walking belt has shifted to the left,
use the hex
key to turn the left idler roller screw clockwise 1/2
of a turn;
if the walking belt has shifted to the
right,
turn the left idler roller screw counterclock-
wise 1/2 of a turn. Be careful not to overtighten the
walking belt. Then, plug in the power cord, insert
the key, and run the incline trainer for a few min-
utes. Repeat until the walking belt is centered.
b.
If the walking belt slips when walked on,
first re-
move the key and
UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller screws
clockwise, 1/4 of a turn. When the walking belt is
correctly tightened, you should be able to lift each
edge of the walking belt 3 to 4 in. (8 to 10 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered. Then, plug in the power cord, in-
sert the key, and carefully walk on the incline
trainer for a few minutes. Repeat until the walking
belt is properly tightened.
a
b
HOW TO MOVE THE INCLINE TRAINER
Before moving the incline trainer, insert the key into the
console, raise the incline to the maximum incline level,
remove the key, and unplug the power cord.
Due to the size and weight of the incline trainer, moving
it requires two or three persons.
Hold the upright firmly
near the console. Tip the incline trainer backward until it
rolls freely on the wheels.
CAUTION: To decrease the pos-
sibility of injury or of damage to the incline trainer, do
not lift the incline trainer by the plastic belly pan. Do not
pull on the console.
Carefully roll the incline trainer on the
wheels to the desired location and then lower it to the level
position.
CAUTION: To reduce the risk of injury, use ex-
treme caution while moving the incline trainer. Do not
attempt to move the incline trainer over uneven
surfaces.
Wheel
Upright
Belly
Pan
Console
