NordicTrack Freestride Trainer FS9i, Руководство пользователя

Страница: 28 / 36

28
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in.
If the console does not display your heart rate
when you use the chest heart rate monitor, see
TROUBLESHOOTING on page 12.
If it is difficult for you to touch the correct buttons on the
screen, the screen may not be properly calibrated. To
calibrate the screen, see step 5 on page 24.
HOW TO LEVEL THE ELLIPTICAL
If the elliptical rocks slightly on your floor during use,
see HOW TO LEVEL THE ELLIPTICAL on page 14.
INCLINE SYSTEM TROUBLESHOOTING
If the frame does not move to the correct incline level,
see step 4 on page 24 and calibrate the incline
system.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power cord.
Next, use a
standard (flat)
screwdriver and
pry the Outer Disc
(20) off the Right
Outer Shield (23).
Locate the Reed Switch (56). Turn the Pulley (73) until
a Magnet (137) is aligned with the Reed Switch.
Next, remove the two M4 x 16mm Screws (98), and
then remove the Reed Switch Bracket (54). Then,
loosen, but do not remove, the two M4 x 10mm Clamp
Screws (126).
23
20
98
54
126
73
137
56