If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver and
the short jumper wire included with the chest pulse
sensor.
1.
Make sure that the power cord is unplugged.
While holding the Upper Handrail (123), remove the
two 3” Bolts (119) and Handrail Washers (120).
2. Remove the indicated screws from the Console Back
(88).
Important: The screws may be different
lengths; remember which screws were removed
from which holes. Remove the Console (81).
3. Peel the paper off the pad on the bottom of the re-
ceiver (A).
Turn the receiver so the small cylin-
der is on the side shown, and press the receiver
onto the bottom of the Console Base (81) in the in-
dicated location.
4. Connect the included short jumper wire (B) to the
wire on the receiver (A). Connect the other end of
the short jumper wire to the PLS2 jack on the back
of the Console (82). If there is a wire already
plugged into the PLS2 jack, unplug it. Note: The
other wires included with the receiver may be dis-
carded. Use the included wire tie to secure wires, if
needed.
Make sure that no wires are pinched. See step 2.
Reattach the Console (81) with the screws.
Important: If the screws are not put back into
the same holes from which they were removed,
the Console will be damaged.
See step 1. Reattach the Upper Handrail (123).
25
88
81
Screws
2
3
81
A
Cylinder
82
4
PLS2
Jack
119
120
69
123
1
B
A
