10
NORDIC
SWITCHING ON AND OFF
Depress the On/Off switch to start and release it to stop your tool. Depress the on/off switch then the lock
on button. Your tool is now locked on for continuous use. To switch off your tool just depress and release
the on/off switch.
CUTTING INSTRUCTION
PLUNGE CUTTING:
The plunge cutting procedure is only suitable for treating soft materials such as wood, plaster board
or similar! Do not work metal materials with the plunge cutting procedure!
Use only short saw blades for plunge cutting.
Place the machine with the edge of the blade foot onto the
workpiece and switch on. For power tools with stroke speed control,
set the maximum stroke speed. Press the power tool firmly against
the workpiece and allow the saw blade to slowly plunge into the
workpiece. As soon as the blade foot fully lays on the surface of
the workpiece, continue sawing alongside the desired cutting
line. For certain work, the saw blade can also be inserted turned
through by 180° and the sabre saw can be guided accordingly in a
reversed manner.
FLUSH CUTTING:
Pay attention that the saw blade always extends beyond the diameter of the material being worked. There
is danger of kickback.
It is possible to make cuts extremely close to floors, walls and other difficult areas. Insert the blade shank
into the blade clamp with the blade teeth facing up (opposite to normal working position). This will make
cuts closer to the work surface. Using special flexible blades insert the blade into the blade clamp with the
blade teeth facing down (normal working position). It will allow flush pipe cutting.
WOOD CUTTING
For easier control use low speed to start cutting, then increase to the correct speed.
