26
Effecta AB - Västra Rågdalsvägen 21 - SE-434 99 Kungsbacka - +46 (0)300 22320 - [email protected]
▀
Ceramics replacement
Eventually it is time to replace the ceramics tray. In the pictures below you can see a cross-
section of Effecta Lambda seen from above. Follow the instructions below for easy replacement.
Installation is done via the loading compartment door.
Start by breaking the old tray. Use a hammer
if the blocks are not easily removed.
Remember to use hearing protection.
Clean the loading compartment from soot
and ash once the tray has been removed.
The new tray will rest on top of the joggle that are
in the loading compartment. They are marked in
red in the pictures. Centre the lower blocks no. 4
and no. 5 laterally and fixate them as far forward
as possible in the loading compartment. Place a
high string, about 2 cm, of the supplied ceramic
mass along the areas that are marked in yellow.
Remember not to seal the hole in the front where
the secondary air is admitted.
Place the distribution plate
in the recessed section of
the bottom blocks. Place
also a string of ceramic
mass on top of the plate.
Now insert the upper
blocks. Fold the supplied
white cloth in half
lengthwise and press down
along the recess along the
long sides. (Marked green)
Now place ceramic mass
along the area marked with
yellow and the ceramics
replacement is complete.
Wait about 24 hours before
firing.
Содержание EFFECTA LAMBDA 35
Страница 1: ...INSTALLATION MAINTENANCE SERVICE ASSEMBLY EFFECTA LAMBDA 35 Rev EA 012 05 30...
Страница 30: ...30 Effecta AB V stra R gdalsv gen 21 SE 434 99 Kungsbacka 46 0 300 22320 info effecta se...
Страница 31: ...31 Effecta AB V stra R gdalsv gen 21 434 99 Kungsbacka 46 0 300 22320 info effecta se...
Страница 32: ...32 Effecta AB V stra R gdalsv gen 21 SE 434 99 Kungsbacka 46 0 300 22320 info effecta se...
