Getting Started
1. Connect the RF antenna to port 1 of the reader and aim the antenna towards the sensing
area
2. Place the sensor tags in clear line of sight from the antenna and around a meter away
3. Power on the reader and connect its Ethernet port to the internet
Note: the reader may use Power over Ethernet if the host is capable, otherwise the wall power
supply must be used
5. Wait a couple of minutes for the reader and ReaderService™ to start
6. Access the ReaderService
™
WebUI by pointing a browser to port 4747 of the reader's IP
address
If the IP address is unknown, follow these steps to use the Wi-Fi provided by the smart reader:
1.
Connect the WLAN antenna to the reader's WLAN port
2.
Connect to the reader's Wi-Fi (name: axzon_demo; password: smartpassivesensor)
3.
Open a browser and go to http://192.168.1.1:4747
If the following error occurs: "Failed to connect to reader service at http://<<ip_address>>:19040"
Wait a couple of minutes and then refresh the page. For more information, refer to the known
issue: WebUI starts before ReaderService
™
7. Ensure ReaderService
™
is connected to the reader module
Navigate to the
settings
page and if not connected, press
Connect
.
