Nordcap 46710404004-K, Руководство по сборке

Страница: 15 / 59

Assembly Instructions
N.º
467_SERIE_MWZ_
AUFBAUANLEITUN
G_2009-03
467_SERIE_MWZ_AUFBAUANLEITUNG_2009-03 15/59
TEC
3 Recommendations for Installation
3.1 General Notes
Although the production of each appliance is rigorously controlled during manufacture, this does not exclude the possibility of
damage caused in transit. The general condition of the appliance should therefore be checked on arrival.
3.2 Placing

Remove the packaging carefully so that the equipment’s surfaces are not damaged. Remove the PVC protection.

The appliance should be installed away from heat sources (ex: heating appliances) and direct sunlight.

To ensure that the appliance functions well, it should always be correctly levelled and slightly inclined to the back, to
make sure that the door closes perfectly. Small differences in level can be compensated for by regulating the feet.
3.3 Installation
The following standards should always be bared in mind during installation:

Regulations concerning the buildings, and anti-fire standards.

Rules concerning accident prevention.

European standards into effect.
4 Recommendations for the User
The STOCK cabinets have been designed to preserve food during short periods of time.
Children should be supervised to ensure that they do not play with the device.
To ensure that they function well, the following points must be followed:

Avoid opening the door as much as possible.

When putting in food, make sure that there is good natural circulation of air inside.

Do not use pointed objects to remove ice.

If you do not follow the above advises, there will be an increase usage electrical energy.
4.1 Cleaning
To ensure perfect hygiene and conservation, clean as follows:

Cleaning the surfaces carefully with a damp cloth.

Always when using water and detergent, make sure these are neutral, and avoiding those which are chlorine-based
or abrasive.

Rinsing with clean water and drying carefully.

It is entirely inadvisable to use pressurised jets of water, especially in the direction of the compressor.
5 Assembly
There is a label on each panel, the darkest side identifies the panel. The dart on vertical panels points to the top.
Proceed to the assembly of the keg box as follows:

Insert the inferior stud-pins with serrated lock washer in the fixing support of the door (Fig. 1);
Fig. 1