Nordcap 44590000, Инструкция по эксплуатации

Страница: 6 / 12

-
Earth wire, thermal magnetic protection and differential are requested for the electric
installation.
Voltage: see characteristics plate.
Maximum consumption: see characteristics plate.
Coolant: see characteristics plate
Coolant charge: see characteristics plate.
2 I N S T AL L AT I O N .
2 . 1 U N P AC K I N G .
-
You are advised to unpack the refrigerator as soon as possible and check it hasn’t suffered
any damage caused by transportation.
-
If the refrigerator has been damaged, you must notify it to the forwarder agency and
annotate it in the delivery note.
-
Check that the cooler has been carried following the position indicated in the packaging. If
the cooler has not been transported in the recommended position, please place it in the
correct position and wait at least 24 hours before using it.
-
When unpacking the cooler, be careful not to damage the product.
-
Recyclable elements are marked.
2 . 2 P O S I T I O N I N G .
Put the cooler in a ventilated place, away from heat sources, 7 cm from any wall and 30 cm from
the next cooler.
Please check the level of the machine, screwing or unscrewing the legs and check if the door
closes properly.
2 . 3 S T AR T I N G - U P .
Connect the cooler to the mains taking into account the aforesaid preventive measures, and put
the main switch in “ON” position. Located in the back side, only for RVCS-250.
ATTENTION: If the power cable shows any sign of damage or imperfections this cable should be
replaced.
The replacement of this cable should only be carried out by the manufacturer, after sales service
or a suitably qualified person.
2 . 4 L I G H T I N G .
The cooler includes illumination by LEDs. They are switched on by means of an interruptor
located outside the machine.
2 . 5 P R O D U C T L O AD I N G .
The cooler has been designed to keep the inner temperature from +0 to +6.6 ºC.
Turn on the cooler and allow it to run empty and undisturbed for at least the first pull-down. The
inner temperature must be within the range mentioned above before loading the products.
Place the product on the shelves and leave enough space between the cans or bottles.
6