APPLIANCE
Rev. 01 of 01/07/2019
Translation of the original instructions in Italian
SOLL.
1.2
Unpacking and positioning
Before starting installation, follow this unpacking procedure very carefully.
1.
Place the appliance, still packed, near the place where it will be installed. To do
this, it is advisable to use a roller trolley, avoiding dragging the appliance in order
not to damage people or property.
2.
When the place has been chosen, make sure there is enough space to open the
main door.
3.
Install the appliance in a dry, well-ventilated place, away from sources of heat (for
example a radiator, hob, etc.) and in a place where it is not exposed to direct
sunlight. If necessary, use an insulating panel.
4.
Insufficient ventilation at the back of the appliance increases power consumption
and reduces the cooling efficiency.
5.
Cut the straps and remove the cardboard packaging upwards. Do not blades, to
avoid scratching the steel panels of the appliance.
6.
Remove the protective box and place the appliance in the final position.
7.
Remove the PVC film from all sides.
8.
Remove the plastic protection from the core probe.
9.
Place the plastic condensate collection tray, which can be found inside the cell
when it is opened for the first time, under the technical compartment, sliding it
into the dedicated rails (ref. 1 Fig. 5.2).
10.
Using the plug that can be found inside the cell when it is opened for the first time,
close the drain hole inside the cell (ref. 2 Fig. 5.2).
11.
Level the appliance vertically by means of the adjustable feet to ensure its stability,
correct air circulation and condensate drainage.
12.
Keep a minimum distance of 10 cm from the sides and the back to ensure correct
air circulation.
13.
After unpacking the unit, make sure that it is not damaged. Any damage must be
reported to the dealer within 24 hours of delivery.
14.
Wait at least two hours before activating the appliance, to allow the refrigerant
circuit to be perfectly efficient.
15.
Clean the inside of the appliance before using it.
9
