Nord Drivesystems SK 180E Series, Руководство пользователя

Страница: 37 / 212

2 Assembly and installation
BU 0180 en-4118 37
2.2 Installation of optional modules
Modules must not be inserted or removed unless the device is free of voltage. The slots may only be
used for the intended modules.
2.2.1 Option locations on device
Figure 5: Option locations, size 1
Figure 6: Option locations, size 2
1
View from left, size 1
2
View from right, size 1
3 View from left, size 2
4 View from right, size 2
The various installation locations for the optional modules are drawn into the drawings shown above.
Option location 1 is used to install an internal bus module.
An internal braking resistor can be installed in mounting location 2 (only available in size 2).
The
braking resistor cannot be retrofitted and must therefore be taken into account in the order.
External bus modules or 24 V power supplies can be implemented at option location 3L or 3R. The
same applies to external braking resistors. Option locations 4 and 5 are used to install M12 sockets or
connectors or also for cable glands. Only one option can be attached in an option location, of course.