w w w . h a w k e y e e l e c t r o n i c s . c o m
N
OTICE
:
If “---” appears on the display, make sure that there is
at least 2.5 feet of water between the bottom of the
transducer and the bottom of the water body. Also
make sure that the Keel Offset feature is turned OFF.
3. Become familiar with the depth sounders function and performance at idle
speeds.
4. Gradually increase the boat speed and observe the depth readings
(pay
attention to minimum and maximum depth capabilities).
5. If you are not happy with the readings there are very little adjustments that
you can do at this time. You will need to remove the transducer and return to
Step 1 of the Glue-In Instructions.
N
OTICE
:
Certain environmental conditions may restrict the
performance of the depth sounder. Extremely dirty water,
very soft bottom, high speeds, deep water, or a combination
of the above will result in incomplete or inaccurate readings. Please
refer to Steps 1 & 2 of this section to minimize the effects of these
conditions. If you are not happy with the performance of your depth
sounder, please visit our support website at
support.norcrossmarine.com for technical support. Rest assured that
this depth sounder is engineered to the highest standards and is part
of the best selling family of depth sounders in the world. It is highly
likely that your dissatisfaction is due to improper installation and/or
setup, and our technical support resources can get your system
working properly.
To Remove the Transducer:
1. Place a piece of wood against the base of the
transducer.
2. Gently “TAP” the piece of wood with a hammer. DO
NOT strike the transducer directly.
3. Once the transducer is removed from the hull, sand
the excess epoxy adhesive off with sandpaper
(minor
sandpaper scratches will not harm the transducer)
.
DO NOT use chemicals to remove the excess epoxy
