w w w . h a w k e y e e l e c t r o n i c s . c o m
To Change the Mode:
1. Press the “UP” Button to change the mode to the Right
(The display will
change modes from Depth to Water Temperature to Air Temperature)
2. Press the “DOWN” Button to change the mode to the Left
(The display
will change modes from Depth to Air Temperature to Water
Temperature)
N
OTICE
:
When a Temperature Mode is selected the Water or
Air indicator will flash on the LCD for 5 seconds while
the temperature is calculated.
SHALLOW WATER ALARM
The shallow alarm function can be set for depths ranging from 3 to 200 feet and
triggers an alarm when the depth is less than the setting. You must be in the
“Depth Sounder” mode to adjust this setting.
To set the SHALLOW ALARM (upper alarm):
1. Press and hold the "UP" and “DOWN” keys until
the
and
indicators illuminate and the
icon blinks.
(approximately 3 seconds)
.
2. Release the Keys.
3. Press the "UP" key to access the shallow water
alarm setting. The icon will illuminate and the
indicator will blink.
4. Pressing the "UP" key will increase the selected value. Pressing the "DOWN"
key will reduce the value.
5. Pressing and releasing the key will change the value in 1-foot increments per
second.
6. Holding down the key will change the value in 9 foot increments per second.
7. After the desired setting is achieved, the display will return to normal
operation after 5 seconds.
8. The
and indicators will now be illuminated to indicate that a shallow
water alarm is set.
When triggered, the alarm sounds an audible buzzer for ten seconds while
flashing the warning LED and the
and icons on the display. After 10
seconds, the audible alarm mutes and the warning LED and the
and icons
continue to blink until the depth increases, or the alarm is reset. To reset the
alarm repeat steps 1 thru 5.
