Norco SHB-970, Руководство пользователя, Страница: 14 / 57

SHB-970
Industrial Full Size CPU Card
5
（
2
）
Hold the CPU by both sides and Position the CPU over the socket, making sure that the
gold triangle is on the bottom-left corner of the socket then fit the socket alignment key into the
CPU notch.
（
3
）
Check if the CPU installation is ok and then close the CPU socket cover.
Please follow the steps below to install CPU FAN:
（
1
）
Make sure the CPU FAN matches well with the CPU surface and then fix the FAN on the board.
（
2
）
Connect the FAN power cord to the board CPU FAN socket.
2.2.2 Install DIMM
Board provides 2x DIMM slots, please keep following points in mind when installing memory
bank:
1. When installing memory bank, please align its notch with the alignment mark on the socket
and then press the memory bank slowly into the socket.
2. Please choose the memory banks that match our motherboard.
2.3 Jumper Setting
2.3.1 CMOS Clear/Hold Jumper Setting
（
JCC1, JCC2
）
CMOS is powered by onboard button cell. Clearing CMOS will lead to permanent elimination
of previous system settings and reset to the original system setting (the factory setting).
Steps:
（
1
）
Shut off the computer and disconnect power supply
（
2
）
Make jumper cap JCC Pin 1-2 short for 5~6 sec and then back to Pin 2-3
（
3
）
Power on the computer and press ”Del” key to enter into BIOS setting when
system starts, then reload optimal defaults
（
4
）
Save and Exit.